This section will cover installing the Dinger Doorstation doorbell. Note the power requirements for this device:
12–33 VDC, 1 A ; Standard PoE
Number
Name
Function
1
Microphone
Audio input.
2
Camera
Capture images/ record videos
3
Call button
Initiates a call
4
Card swipe area
Swipe the registered cards to unlock doors.
5
Speaker
Audio output.
Number
Name
Function
1
Network port
Connects to the network. Powers using PoE.
2
SD card slot
For storing images/ recorded videos. Supports up to 256GB.
3
Reset button
Press and hold the button for at least 30 seconds to
Reset it to factory settings. Use if the password has been lost.
4
Multi-function port
See the label on the pigtail/ dongle above for functions.
Step 1 Mark the Mounting Holes. Place the mounting bracket to fit your existing doorbell wiring and then use it to mark the screw holes.
Step 2 (Optional) Install Wall Anchors. If installing on stucco, brick, or concrete, use the a drill bit to drill holes where marked, and then insert the included wall anchors. For wood, drywall or soft surface, skip this step.
Step 3 Secure the Mounting Bracket. Lead the doorbell wires through the hole on the mounting bracket, and then secure the bracket to the mounting surface with a Philips-head screwdriver and supplied mounting screws.
Step 4 Connect the Wires. Loosen the power port screws of the doorbell if necessary or plug in a PoE power source, then loop your existing wires underneath the screws.
Step 5 Mount the doorbell. Install the supplied sunshade if necessary. Tighten the screws to secure the power wires, then push the wiring back into the wall. Place the doorbell onto the locking tab of the mounting bracket, and then slide it down to secure it in place. Use the supplied grub screw to secure the doorbell to the mount.
Without Sunshade:
With Sunshade:
Still stuck?
Chat with our support assistant at any time, and it can pass you to the support team. Or email us a request. It helps to have these ready:
Our support team answers by email. It helps to have these ready:
Model numberSerial numberFirmware or app versionWhat you have tried